2N® Lift8 with New SW and Application for Google Play
At the end of April, we have released the new 1.10.1 version of software for the 2N® Lift8 lift communicator. We have also developed a simplified version of the 2N® Lift8 Service Tool application for devices with an Android operating system.
In addition to correcting errors, the new version 1.10.1 firmware for the 2N® Lift8 communication system includes the following improvements:
- Support of a new anti-vandal shaft unit – which has the highest class IP65 cover and is impact-resistant in accordance with the IK10 standard.
- Configuration of the camera module as an independent unit for the 2N® Lift8 via a web browser – this enables the complete set-up of modules, browsing and downloading of recorded image files, relay control, etc.
- Improvement of control calls using an active check of the speaker and microphone for audio units (an audio loop test) – there is an automatic check of these devices before a control call is made. In the event an error is found, a control call is not made.
There is also a significant innovation in the 2N® Lift8 Service Tool software application. In a simplified version, it is also newly available for devices with an Android operating system. This version is primarily designed for use at the point of installation. It allows configuration of the parameters of the central unit of the 2N® Lift8 communication system, such as control calls, alarm calls, protocol selection, etc.